Welcome to the official website of Nanbei Group

Ice crusher general operation procedure

Jun 13,2014

1, sand ice machine should be installed in the sufficient supporting force of the work table, and a proper distance with the ground.

2, before power on, first check the use of power supply voltage, andthe voltage is consistent, the outlet is in compliance with safety standards, and has installedelectrical leakage protection switch and receive good ground wire. Confirm all meet the electricity requirements.

3, before the start, the ice broke to a diameter of about 20 mm, can put in the barrel,top with convex feeding cylinder mouth is appropriate. Pay attention to the opening the power switch, themotor with a power disc rotation are allowed to board pneumatic materials pressing cover with handle is pressed downwards, then through the fastening rotary cutter blade on the ice to the shredding. But the operation handle is pressed downwards pressing cover when not too hard, so as not to damage the motormotor locked-rotor. And should pay attention to material is reduced after the ice margin, timely replenishment of the new ice block.

4, chopped ice particles, through the discharge opening into thedish. Be aware of blowdown smoothly, must not be blocked, otherwise it will cause death card cutter, burn motor. Such as the discovery of cutter is blocked, should be instituted immediately pressing cover with handle, closing the switch, pull the plug, the timely troubleshooting.

5, ice thickness can be adjusted by a blade mouth is convex cutter height to achieve, when adjusted to remove the protection switch device of the plastic disc, loosen the fixing pipe screw, pull out the barrel, and then release the cutter fastening screws, remove the knife disc, and then release the pressure screw blade, according to your requirements, installation in place, then in order to cutter mounted back to.