Hello. Air injected iron filters use oxygen to oxidize iron and manganese. If they come at zero, which should be the case, I will consider the H2O2 only to kill the pathogens and get a better oxidation. That wasn't in the cards for me so peroxide injection was the most cost effective route in my case. Nelsen AIO. Hello. 3/4″ or 1″ Noryl Male Threaded Plastic Bypass https://www.uswatersystems.com/infusion-backwashing-filter-for-iron-sulfur-and-manganese-removal.html
I recently discovered that a company that starts with a "K" and ends with an "O" is clueless. General Information Specification Sheet. Our old water conditioner did not take all the iron out but it was 22 years old.
Carbon block filters work well after Aer-Max if no iron is present. i'm hearing that our well water has approximately 6 ppm of iron. 5.) #8. It is … 1.) ® ® IRON Eater Iron Filter With Air Injection (Great for High Iron, Mang & Smell) $ 599.00; Fleck 5600 SXT Eradicator Metered 2000 SXT Water Softener/Filter Eradicator $ 895.00; Product categories Quick Links. I purchased KO's water softener and standard iron filter system when I built my home on the guise that this tiny municipal water plant would be the one and done solution to my water needs. I have a cistern added, low (yield well)! The Fleck 2510 SXT AIO system removes up to 15 PPM iron, removes 15 PPM of hydrogen sulfide that causes rotten odors in your water, and removes up to 5 PPM manganese. https://www.uswatersystems.com/us-water-lab-water-test.html. Air Injection Platinum 10. No sludge! I'm not disagreeing that H2O2 is a better oxidizer, but I'm also not so sure that they will just sludge up like that unless something was done incorrectly. This system will delay the regeneration process and air release if water is being used in the home or business. What is the level of the hydrogen sulfide? Thanks. The backwash system is working fine. This is done once a month to clean the valve. https://www.uswatersystems.com/infusion-backwashing-filter-for-iron-sulfur-and-manganese-removal.html. Ships Loaded for easier installation When using oxygen alone, the oxidation process starts as soon as the oxygen touches the water. The iron filtration product link is: http://csih2o.com/products/iron-sulfur-filters/sidekick-single-tank-aeration-filter Thanks again for your article and any assistance you can provide.. John, Can I use hydrogen injection before the AIO filter and use it’s catalytic carbon to filter what the hydrogen peroxide oxidizes and peroxide out. Here’s a blog that is an update to our new technology: https://www.uswatersystems.com/blog/air-injection-revisited. I would recommend this to anyone that has sulfate in there water. For use on cold water only. How much iron do you have? What to do. Air Injection Iron Eater Filter Great at Removing Iron Manganese, H2S Whole Home, Almond Series: Amazon.sg: Home Improvement It depends upon your perspective. Great At Removing Iron Note: water must free of H2S (smell) & Ph Above 6.8. They say that is normal. I'm wondering how expensive is the H202 and what would be the aproximate rate of use? First impressions on USWater - knowledgeable - helpful. I have an air injection type iron filter and may have iron bacteria in my system and the filter. Since rust is a particle, it can be easily removed by Rainfresh sediment filters but ferrous iron requires specific removal process such as the Air Injection Iron Filter. The Truth About Air Injection Iron Filters. adroll_version = "2.0"; You should also use proportional injection, like these systems:
Residential Ultraviolet Water Disinfection, Residential Ultraviolet Surface Disinfection, Deionized TDS Controllers, Resistivity Monitors & Water Quality Lights, The Truth About Air Injection Iron Filters. The Fleck 2510 SXT AIO system removes up to 15 PPM iron, removes 15 PPM of hydrogen sulfide that causes rotten odors in your water, and removes up to 5 PPM manganese. Fleck 2510SXT Air Injection Oxidation (AIO)
To remove ferrous iron, you can use an air injector in combining with the filter to remove the iron up to 30 mg/l. We can solve your problem but I need a lot more information. H2O2 is a poor disinfectant but a great oxidizer. I used aeration for iron removal for 15 years. This brand is perhaps one of the best well water filters that can remove iron. 10×54″ mineral tank 25 Hardness / 3.6 ppm Iron / 7.5 pH / 930 ppm Total Dissolved Solids
• COMPLETE SYSTEM DIMENSIONS 10X10X56, • 2.0 CUBIC FEET OF MEDIA • 10X54 INCH MINERAL TANK We sell the same unit as Kinetico https://www.uswatersystems.com/flexx-oxi-gen-aeration-iron-and-sulfur-filter.html, but we recommend a maximum of 10 ppm of iron (and that is with the Ozone Option), and do not recommend it on water that hard iron or sulfur-reducing bacteria. It is expensive, but in my life, I have found that cheap things aren’t good and good things are not cheap. I am tired of maintaining my pressurized air injector system. I can say that I haven't used a furnace in 15 years, but if I live in Key West, what correlation is that to people who live in Alaska? Since rust is a particle, it can be easily removed by Rainfresh sediment filters but ferrous iron requires specific removal process such as the Air Injection Iron Filter. I have chloringated the system in the past but have bypassed this filter assuming 200 ppm of chlorine is too much for this filter. #4. You need this before the softener:
The AIO value was completely clogged with iron. Here it is again: The water has low pH of minus 4 ppm probably due to the cistern and iron levels of plus 5 ppm, also a hardness, nitrite and nitrate level of 0 ppm. https://www.uswatersystems.com/infusion-backwashing-filter-for-iron-sulfur-and-manganese-removal.html
I followed the link for the equipment you suggested in a previous post but it is very expensive (https://www.uswatersystems.com/infusion-backwashing-filter-for-iron-sulfur-and-manganese-removal.html) Any advice? But I am looking for a rust removal system for a well-sourced water supply (Florida coast) lawn irrigation application. DuraWater IRON EATER Air Injection Iron Filter The DuraWater iron eater air injection oxidizing system, as a single tank system, is an efficient and cost effective system for the removal of iron and sulphur. I have had an air injection system for some time(8 yrs) with no problems. This iron water filter does an excellent job of removing up to 10 PPM of iron and up to 6 PPM of hydrogen sulfide. When you’re dealing with ferric iron, you may need something that oxidizes, which is where systems like the Air Injection Silver come in handy. So here are my questions:
The Iron filter maintains an “air pocket” in the top of the tank while the system is in service. https://www.uswatersystems.com/us-water-lab-water-test.html
Hey, just want to make one comment regarding air injection. Was thinking going the O3 route instead then? #5. I tried to talk to the good people at nelson about this and they say its normal to have a little air it should dissipate after 30 sec or so.
CDN$1,199.00. The AIO system maintains an “air pocket” at the top of the tank. This had two problems: Such extreme levels of Iron require a HUGE oxidation dose for complete precipitation. In fact, we currently are using that technology with our Smartphone app which gives us better control of the system. By utilizing just one tank, your maintenance costs will be minimal. If you have "low to moderate" iron, they may work for a while, but many are doomed to failure in the long-term.